The camera zooms in on the LED. Watch the signals in sequence or choose a state below.
The controller is not powered.
The status LED is not available on version 1.15.0.9 and earlier.
| LED Color | Behavior |
|---|---|
| Off | The MidTeQ PULSE EMS is not powered on |
| Green / blue | The MidTeQ PULSE EMS is booting |
| Green | The MidTeQ PULSE EMS is operating as normal |
| Purple (heartbeat blinking) | The MidTeQ PULSE EMS has no internet |
| Alternating blue and green (every half second) | A software update is in progress |
| Red / yellow (blinking) | The reset button is pressed |
| Red | The reset button has been held for 5 seconds and the factory reset has started, or the MidTeQ PULSE EMS is in error state |
The camera zooms in on the LED. Watch the signals in sequence or choose a state below.
The controller is not powered.
| Power LED | Behavior |
|---|---|
| Off | The MidTeQ PULSE EMS is not powered on |
| On | The MidTeQ PULSE EMS is powered on |
| Status LED | Behavior |
|---|---|
| Erratic on/off | The MidTeQ PULSE EMS is booting |
| Continuously on | The MidTeQ PULSE EMS is operating as normal |
| Heartbeat blinking | The MidTeQ PULSE EMS has no internet |
| Slow blinking (on and off, about once per second) | A software update is in progress |
| Three fast blinks followed by three slow blinks | The MidTeQ PULSE EMS is in error state |
The MidTeQ PULSE Controller does not have status LEDs.
The camera zooms in on the LED. Watch the signals in sequence or choose a state below.
The controller is not powered.
The MidTeQ PULSE Controller (Model M2S) is supported from software version 2.0.
The MidTeQ PULSE Controller has one multi-colour status LED. Once the software is running, it uses the same colours as the Model OM1.
| LED Color | Behavior |
|---|---|
| Off | The MidTeQ PULSE EMS is not powered on |
| Blue | The MidTeQ PULSE EMS is booting |
| Green | The MidTeQ PULSE EMS is operating as normal |
| Purple (heartbeat blinking) | The MidTeQ PULSE EMS has no internet |
| Alternating blue and green (every half second) | A software update is in progress |
| Red / yellow (blinking) | The reset button is pressed |
| Red | The reset button has been held for 5 seconds: release it now to start the factory reset. Red is also shown when the MidTeQ PULSE EMS has crashed |
On the MidTeQ PULSE Controller the factory reset starts when you release the reset button, not while you hold it. Release the button as soon as the LED turns red. If you release it earlier, nothing is reset. After the reset the MidTeQ PULSE EMS reboots: the LED turns blue while it starts and green when it is ready.